Edison Coatings, Inc. Products are manufactured in the USA from US and foreign components.
E-NHL 2, E-NHL 3.5 White and E-NHL 5.0 are Products of France. E-NHL 3.5 Buff and Ruregold are Products of Italy. Marfil is a Product of Spain.

PUMP-X53, 53i, 53iE, 53iL
PUMPABLE INJECTION GROUTS & FILLERS
 

DESCRIPTION:
PUMP-X53-Series products are prepackaged specialty grouts used for a wide variety of construction, restoration and masonry stabilization applications.

PUMP-X53 is a multi-purpose, low modulus, moderate strength filler used for filling cavities, voids and cracks from a minimum of ¼" width up to approximately 18 inches. It is a two-component, latex-modified, super- plasticized lime-cement mortar designed for broad compatibility with masonry structures.

PUMP-X53i is an ultra-fine, moderate strength micro-injection grout which achieves high flow for efficient filling of small cracks and voids from a minimum width of approximately 1 mm to as much as several inches in thickness. It is a single component, polymer-modified mortar which is mixed with water to achieve fluid working consistencies without separation or bleeding.

Pump-X 53iE is an ultra-fine, expanding,  non-polymer cementitious injection grout designed for filling small cracks and voids in sound concrete and masonry construction. Slight expansion after placement and before final set enables the material to force itself into close, positive contact with internal crack surfaces, where desired.

PUMP-X-53iL is a softer, non-polymer, pozzolan-lime grout, for use in Historic masonry restorations requiring repairs to lower strength brick and softer stone elements.

CUSTOMIZATION:
PUMP-X53-Series products can be customized for specific project requirements. Typical customizations may include color-match, strength adjustment, addition/deletion or change in concentration of polymers, acceleration or slowing of set time, increase or reduction in expansion properties or alteration of other performance properties.

Pump-X53, 53i, 53iE, 53iL Data Sheet

Pump-X53 SDS

Pump-X53i, 53iE, 53iL SDS
 

LIMITS OF LIABILITY

Edison Coatings, Inc. makes no warranties, express or implied, as to the accuracy or completeness of any of the information contained herein. This publication is offered on a complimentary basis as a service to potential customers or specifiers. While every effort has been made to include complete and accurate information, based on data and information believed to be reliable, it is the sole responsibility of the user to determine its suitability for his own intended use and purposes. Nothing contained herein shall be construed as a warranty or guarantee of any product, process or any other recommendation stated herein. Edison Coatings, Inc. assumes no responsibility for advice given, results obtained, or for any damages whether incidental or consequential, which may be incurred as a direct or indirect result of the use of this information. By proceeding to use this information, user acknowledges and agrees that he is doing so at his own risk, and user indemnifies and holds Edison Coatings harmless against any liabilities, costs or expenses resulting therefrom. All product sales are further governed by the Edison Coatings, Inc. CONDITIONS OF SALE. Privacy Policy.

Copyright 2016, Edison Coatings, Inc. All rights reserved.